4. Troubleshooting
4.3. Buyer-Region Code Setting Method
4.3.1. Inserting the Region Code after replacing the Main PCB
NOTE
•
When replacing the MAIN PCB Ass’y, system micom IC(UIC1) should have proper region code.
•
The Set is not working properly if you don’t insert Region code.
•
The region code can be inserted by the remote control.
1) Change function mode to "AUX".
2) Press the “Tuner Memory” button on the remote control during 4~5 seconds.
(2)
(3)
3) After step 2. you can see “T-MODE” on the VFD and press direction button “▼” during T-MODE. (please remind that
“T-MODE” indicator on the VFD is appeared for a very short time)
T
-MODE
4) After step 3. you can see “TEST - -” on the VFD. Insert number 46.
TES T − −
5) After step 4. you can see “- - -” on the VFD. Insert Region code (refer to below table) corresponding model and
buyer using remote control.
−
− −
4-20
Copyright© 1995-2013 SAMSUNG. All rights reserved.
