|
18
English
Connections
\
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.
\
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.
\
If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.
\
In 2-CH mode, you will hear no sound from the wireless surround speakers.
|
NOTE
|
\
If you place a speaker near your TV set, the screen Color may be distorted because of the magnetic field.
\
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, sound
from the speakers may be disrupted because of interference.
\
If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses the 2.4/5.8GHz frequencies near the
product, sound from the speakers may be disrupted because of interference.
\
The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary depending on your
operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may
not operate at all, because the radio wave cannot penetrate metal.
\
If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the
product turned off, press "0"
"1"
"3"
"5" on the remote control. Turn on the wireless receiver module. Then, press and hold the “
ID
SET
” button on the back of the wireless receiver module for 5 seconds, and then turn the product on.
Connecting the FM Antenna
1 .
Connect the FM antenna supplied to the FM
ANTENNA Jack.
2 .
Slowly move the antenna wire around until you find
a location where reception is good, then fasten it to
a wall or other rigid surface.
|
NOTE
|
\
This product does not receive AM broadcasts.
FM Antenna (supplied)
Connecting to an iPod/iPhone
Connect an iPod/iPhone using the USB cable to the rear
USB port.