English
19
02
Connections
CAUTION
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and
moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer location is
clear of any obstructions.
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
Keep the subwoofer speaker out of reach of children so as to prevent children from inserting their
hands or alien substances into the duct (hole) of the subwoofer speaker.
Do not hang the subwoofer on the wall through the duct (hole).
NOTE
If you use a device such as a microwave oven, wireless LAN Card or any other device that uses
the same frequency (5.2/5.8GHz) near the product, some sound interruption may be heard due
to interference.
The transmission distance of radio wave is about 10M, but may vary depending on your operating
environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless
subwoofer, the system may not operate at all, because the radio wave cannot penetrate metal.
If you place a speaker near your TV set, screen colour may be distorted because of the magnetic fi eld
generated by the speaker. If this occurs, place the speaker away from your TV set.
If the subwoofer is not connected from the power, you will see
S/W CHECK
on the display panel of the
main unit.
Place the wireless subwoofer under the main unit.
If the main unit doesn't make wireless connection, the
system needs ID Setting between the main unit and
wireless subwoofer. With the main unit turned off, press
the remote control's "0"
"1"
"3"
"5" number
buttons and then turn on the unit. After connect to the
power, press
ID SET
button on the rear of the
subwoofer for 5 seconds.
Attaching the Toroidal Ferrite Core to the Speaker Cable
Open the bigger one of two toroidal ferrite cores by pulling the lock
lever.
Arrange all the speaker cables that are connected to the subwoofer
and make two loops.
Attach the ferrite core as close as possible to the subwoofer.
Place the toroidal ferrite core on the looped speaker cable as
shown, and then press it closed it until you hear a click.
!
✎
1.
2.
•
3.
ID SET
R
ID SET
L
ID SET button
HT-D7100_ELS_1227.indd 19
HT-D7100_ELS_1227.indd 19
2011-12-27 1:18:42
2011-12-27 1:18:42
