1
English
English
1
02
Connections
Installing the Speakers on the Tallboy Stand
* HT-D355K only - Front/Surround Speakers
Turn the Stand Base upside-down and connect it to
the Stand.
Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
CAUTION :
When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
1.
2.
!
1
2
Stand
Stand
Base
Connect the upper Speaker to the assembled Stand.
Insert another large screw (5*15, For connecting Speaker
& Stand)
clockwise into the hole on the rear of the
speaker using a screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
3.
4.
5.
5
4
3
Stand
Speaker
Installing the Speakers on the Half Tallboy Stand
* HT-D353HK only - Front Speakers
Stretch out the speaker cable and arrange it through
the hole of the stand base as shown.
Tighten the stand nut (C) as shown and use the stand
screwdriver (D) to tighten it in the arrow direction.
This is after the speaker is installed completely.
Tighten the other speakers in the same manner.
1.
2.
3.
Adjusting the height of the Half Tallboy Speaker
* HT-D353HK only - Front Speakers
If you want to change the speaker position (height),
remove two screws in the rear side.
Pull up the speaker in the arrow direction as shown.
(See fi gure 2)
CAUTION :
Do not apply excessive force. Otherwise, it
may cause a physical injury.
1.
2.
!
1
2
1
2
3
Summary of Contents for HT-D350K
Page 36: ......
Page 72: ...Code No AH68 02352W 03 ...