4-5. White Ratio (Balance) Adjustment
You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
1.
Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS,
2.
Component 1 and HDMI 1 modes.
The optimal values for each mode are configured by default. It varies with Panel’s size and Specification.
3.
Equipment : CS-210
•
Pattern: MIK K-7256 #92 “Flat W/B Pattern" as standard
•
Altenate Equipmet : CA200& anyone Master supported
•
pattern#92(refer to right photo)
Use other Equipment only after comparing the result
•
with that of the Master equipment.
Set Aging time : 60 min
•
Calibration and Manual setting for WB adjustment
HDMI : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
•
COMP: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
•
CVBS: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (PAL)
•
Note
If finishing in HDMI mode, adjustment coordinate is almost same in AV/COMP mode.
White Balance Manual adjustment
UE32ES55**/57**/58**
•
P-Mode
Input source
Section
Adjustment Coordinate CA-210
HDMI
COMP
VIDEO
W/B High
Hx
264
Hy
274
HY
NA
W/B Low
Lx
NA
Ly
NA
LY
NA
MOVIE
W/B High
Hx
318
Hy
340
HY
NA
W/B Low
Lx
NA
Ly
NA
LY
NA
Sub Contrast
135
Sub Bright
128
R-Gain
ADJ
G-Gain
128
B-Gain
ADJ
R-Offset
128
G-Offset
128
B-Offset
128
4-34
4. Troubleshooting