Installation
Installation
English
22
3.
Use the provided nut connector to connect the water hose to the dishwasher.
Follow these steps:
01
02
03
A
B
C
E
D
F
01
Disconnect the
90° fitting (A)
from the
hose (B)
.
02
Remove the
seal (C)
and the
nut (D)
from the 90° fitting.
03
From the provided nut connector, separate the
seal (E)
and the
nut (F)
, and then
assemble them to the 90° fitting as shown in the figure. You must insert the smaller
side of the seal.
4.
Then, insert the
3
/
4
" 90 degree fitting into the inlet valve (See
Figure 4-B
). Tighten until
the
3
/
4
" fitting is tight. Do not over tighten.
5.
Detach the Velcro strips that secure the drain hose to the back of the dishwasher. Roll-
out the hose. Make sure there are no kinks and that the hose is not bent at any extreme
angles that could constrict the flow of water.
6.
Remove the junction box cover located at the bottom front right of the dishwasher
using a screwdriver, and then Install the strain relief (
Figure 4-C
). Make sure to keep
the junction box cover you removed. It is used in
STEP 12
, Wiring Connections.
7.
If the countertop is made of wood or a material that is not damaged by drilling, attach
the two (2) Installation brackets that were supplied with the dishwasher using the
supplied screws (
Figure 4-A
). They will be used in
STEP 10
, Securing the Dishwasher.
If the drain hose needs to go to the
right of the dishwasher, secure the
drain hose into the drain hose bracket,
mounted on the base.
The drain hose bracket can be adjusted
in 3 positions. To adjust the height
of the drain hose bracket, gently
squeeze the bracket and turn it too the
left. Insert the bracket in the desired
position and turn it to the right to lock
it into place.
DW5000C_DW80CB507012AA_DD68-00260A-00_EN.indd 22
DW5000C_DW80CB507012AA_DD68-00260A-00_EN.indd 22
2023-05-03 11:50:04
2023-05-03 11:50:04
