English
23
Engl
ish
• Remove the terminal block cover plate.
• Insert the power cord with a UL-listed strain relief through the hole provided in the cabinet near the
terminal block.
• A strain relief must be used.
• Do not loosen the nuts already installed on the terminal block. Be sure they are tight.
• Use a 3/8” (1 cm) deep well socket.
• Since january 1, 1996, The national electric code requires that new wiring (not existing) utilize a 4-wire
connection to this dryer.
STEP 2
Level the dryer
Before you install the dryer, make sure you have read the Installation requirements on
page 9. Please note that the following instructions are for installation without using a
drain hose. For instructions on using a drain hose, see the next section, Drain hose (if
necessary) on page 20. For convenience, consider installing the dryer next to your washer.
A
B
1.
Carefully move the dryer to the desired location.
2.
Use a
level (A)
and check the levelness of the
dryer from side to side and front to back.
3.
If the dryer is not level, adjust the
levelling legs
(B)
. Turning a leg counter-clockwise retracts the
leg. Turning a leg clockwise extends the leg.
4.
Once the dryer is level, make sure the dryer
stands firmly on the floor.
5.
Plug in the dryer.
DV6900B_SimpleUX_WEB_Heatpump_EN.indd 23
2022/8/30 17:01:55
