Refer
ence
Operating The Receiver
GB-27
GB
GB-26
D
i
g
i
t
a
l
T
e
r
r
e
s
t
r
i
a
l
R
e
c
e
i
v
e
r
TROUBLESHOOTINGS
Problem
Possible cause
Solution of the problem
No display LED on
Power cord
Power cord plug in correctly
the front panel;
not plugged in correctly
No power supply
No pictures on the screen
Receiver in Standby mode;
Set receiver to “On”;
Scart not connected tightly
Check connection and correct;
to video output of television;
incorrect channel or video
Check channel and video output and
output selected on television
correct (TV instruction manual)
No sound
Audio cord connected
Check connection and correct;
incorrectly;
Loudness level = 0;
Increase loudness on television set;
Muting active
Press the MUTE key
Remote Control does not
Incorrect operation;
Point remote control
operate directly
towards the Receiver.
Batteries dead or inserted
Replace batteries or insert correctly
incorrectly
Poor picture quality
Signal strength too low
Check the signal strength in
the “Manual Scan” menu, correct
alignment of your antenna
On-Screen Error Message
Antenna cable not connected
Check connection and correct;
“Searching for signal”
or not tight;
incorrect position of the
Check position and correct,
antenna;
Check the signal strength in
the “Manual Scan” menu
On-Screen Error Message
Receiver not yet set
Scanning of in “Installation” menu
“Channel data does not
exist.”
The device, packaging material (e.g. Styrofoam) and the batteries must never be
disposed of with household refuse. Please obtain appropriate information about the
regulations in your community, and dispose of all refuse in accordance with regulations
at the separate locations provided.
In some region, the digital terrestrial signal may be weak.
So you’d better use the antenna in which the booster was built, for watching the
weak signal channels.
You can download and upgrade the system software of the receiver through
a specific channel designated by the broadcaster.
The Distributor will provide you with more information about that.
DISPOSAL
OPERATING THE RECEIVER
4.5 Software Update
Using this function, you can check if a new version of the
software is available and upgrade the software if available.
●
To upgrade the software, select ‘OK’ and press the
OK
key.
●
Selecting this will take about 2 minutes to check if a new
version of the software is available. If a new version is
available, the software upgrade starts.
●
If there is no new version, the “You don’t need to
upgrade software!” message appears.
●
To cancel the upgrade, select ‘Cancel’ and press the
OK
key.
MD68-00296A_GB 4/27/06 2:11 PM Page 26
