DSR 3800, DSR 3700
6
D
I
G
I
T
A
L
S
A
T
E
L
L
I
T
E
R
E
C
E
I
V
E
R
DSR 3800, DSR 3700
7
CONNECTING YOUR "DSR 3800, DSR 3700"
8. INSERTING COMMON INTERFACE CAM AND SMARTCARD
The DSR 3800 supports Common Interface CAMs under DVB specification.
The CI CAMs include a built-in smart card reader.
●
Insert the smart card into the CAM gently with the gold colored chip upwards
●
Slide in the CAM gently inside the slot so that it sits in the socket tightly.
●
Close the door.
●
To remove the CAM push the button provided by the side of the CAM slot.
The CAM will be ejected from the socket.
N
No
otte
e
: The following Common Interface CAMs are available now:
IRDETO, CONAX, CRYPTOWORKS, VIACCESS, NAGRAVISION, SECA, Etc.
1. LOCATION OF THE RECEIVER
Your DSR 3800, DSR 3700 should be placed under proper ventilation.
Don’t put in completely enclosed cabinet that will restrict the flow of air,
resulting in overheating.
The location should be safeguarded from direct sunlight,
excess moisture, rough handling or household pets.
Avoid stacking other electronic components on the top of the receiver.
The location should be safely accessible by the cable from your
antenna system.
2. CONNECTING THE RECEIVER WITH DISH SYSTEM
After installing your antenna system, connect the coaxial cable from the LNB of
your antenna to "LNB" terminal marked at the rear of the DSR 3800, DSR 3700.
All cable connectors should be finger tightened; do not use any kind
of wrench while tightenning connectors. The cable should be 75ohm
impedance coaxial twisted at the end with an "F" type connector.
3. CONNECTING THE RECEIVER TO TV
To connect the receiver with your television, you can use three methods;
RF cable, or RCA cable.
Connect the RF cable to the terminal marked "AV OUT" at the rear panel
of DSR 3800, DSR 3700 and its other end to the TV RF input socket.
In the case of connecting your TV through RCA cable, connect the RCA
connector marked TV to the respective RCA port on the TV.
4. CONNECTING YOUR ANALOG RECEIVER
To facilitate the user using analog receiver to view analog channels,
DSR 3800, DSR 3700 has been provided with a loop through terminal marked
as "LOOP".
Connect the coaxial cable from this terminal to the IF input terminal of
your analog receiver. Now by keeping the DSR 3800, DSR 3700 in standby,
you will be able to tune and view analog channels from your analog receiver.
5. CONNECTING YOUR VCR
To connect a VCR, the DSR 3800, DSR 3700 has been provided with RCA
at the rear marked "AV OUT".
Using a RCA connector, the VCR can be connected to the receiver.
6. CONNECTING EXTERNAL AUDIO / HI-FI SYSTEM
To connect any external Audio Hi-Fi system, the receiver has been provided
with two RCA connectors at the back of the receiver, marked with AUDIO L and R
respectively to connect the left and right Audio.
Connecting Figure
CONNECTING YOUR "DSR 3800, DSR 3700"
DSR3800_3700_6.28 7/8/02 11:59 AM Page 6
