22_
setting up
INSTALLATION OF THE WATER
LINE
Before You Install the water line
• The water line installation is not warranted by
the refrigerator manufacturer.
So before you install the water line, read the
whole steps for installing and follow these
instructions carefully to minimize the risk of
expensive water damage.
• Banging pipes (water banging in the pipes) in
house plumbing can cause damage to fridge
parts and lead to water leakage or flooding.
Call a qualified plumber to correct the problem
before installing the water supply line to the
fridge.
• To prevent burns and product damage, do not
hook up the water line to the hot water line.
• Do not install the water line in areas where
temperatures fall below freezing.
• When using any electrical device (such as
a power drill) during installation, be sure the
device is insulated or wired in a manner to
prevent electric shock.
• All installations must be in a accordance with
local plumbing code requirements.
• Water line Kit and water filter are not
covered by Samsung’s Warranty. The
manufacturer (or dealer, installer) of them
is responsible for any defects and all the
loss caused by water filter & water line
kit.
• The filter should be replaced according to
manufacturer (or dealer)’s instruction.
• To order additional water filters, please contact
the manufacturer (or dealer) of the filter.
• The new hose-sets supplied with the appliance
are to be used and that old hose-sets should
not be reused.
Using the water filter (not provided)
Connecting to water supply line
• Shut off the main water supply line and turn the
Ice maker to the off position.
• Locate the nearest cold drinking water line.
• Follow the instructions in the water filter
installation kit.
• After connecting the water supply line to the
Cartridge Holder inlet and installing the Filter
Cartridge (insert plastic line in fully).
• Turn on water supply and Flush 11 L through
filter before use (flush approximately 6 minutes)
• The water filter must be installed outside
the refrigerator.
It is not provided with your new
refrigerator. The filter cartridge (8) and
holder (9) kit can be purchased from
the retailer where you purchased this
refrigerator.
• Do not use copper line.
• Cut the tubing, making sure the ends are
square and clean.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
Use Plastic Tubing
• 7 mm copper tubing
• 7 mm compression nut
(1 PC)
• Ferrule (2 PC)
• 7 mm plastic tubing
→
Molded end(Bulb)
• 7 mm compression nut
(1 PC)
Connect the water line to the fridge
• Connect the plastic line on the back of your
fridge to the cartridge holder outlet (fully insert
the plastic line to the cartridge holder outlet).
• Insert plastic clip to the cartridge holder inlet
and outlet.
• Turn water on and check for any leakage.
90 degree
1. Cold Water line
2. Pipe Clamp.
3. Plastic line
4. Compression Nut
5. Compression Sleeve
6. Packing Nut
7. Shut Off Valve
8. Filter Cartridge
9. Cartridge Holder
Incorrect
Correct
DA68-02787A (EN)-05.indd 22
2017. 8. 9. �� 10:51
