8-22
Chapter 8. Troubleshooting
Samsung Electronics
Traninung Manual
8-22
Chapter 8. Troubleshooting
Samsung Electronics
Jam In Duplex Path
Paper is caught while printing side 2.
1. Open the Duplex Cover and then remove the paper.
2. Remove any foreign objects in the Duplex Path.
Jam In Exit Area
Paper is caught in the Exit Area.
1. Check the Exit Sensor actuator.
--> Replace the Fuser if the Exit Sensor actuator is damaged or bent.
2. Check that the Paper Guide Rib of the Output Guide is clean, and not damaged or distorted.
--> Replace the Fuser or Exit Ass'y if it is not normal.
3. Check the condition and operation of the Fuser Rollers.
Jam Inside Printer
Paper is caught inside printer
1. Open the Duplex Cover and then remove the paper.
2. Check the Feed sensor actuator.
--> Replace the Feed Sensor if it is damaged or distorted.
Jam 0 In [Tray]
Paper is caught in the tray.
1. Open the Duplex Cover and then remove the paper stuck in the machine.
2. Open the appropriate tray and after removing any trapped paper ensure that the tray is properly loaded, not over-
filled and that paper guides are properly adjusted.
3. Check that the Feed Sensor is fitted correctly and is free to operate.
4. Use EDC Mode to check the operation of the feed sensor.
4. Check that the operation of the appropriate Pick-Up Clutch under the Cassette is normal.
5. If the Clutch does not work check the condition of the cable harness to the Main PBA.
6. Replace the Main PBA if the voltage on Pin 2 of CN32 (FCF) or Pin 2 of CN25 (MPF) on the Main PBA is +24VDC.
(Normal Output : Pin 1 = +24VDC, Pin 2 = 0V)
