35
DisplayPort Ver.
Select your Displayport.
―
Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
―
If the product (when set to
DisplayPort
) is displaying the message
Check the cable connection and the
settings of the source device.
press the JOG button to display the Function Key Guide screen and then select
→
System
→
DisplayPort Ver.
→
1.1
,
1.2
or
1.4
.
―
If setting the
DisplayPort Ver.
to
1.1
, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual
maximum output refreshing rate of the graphics cards cannot achieve the level of 120 Hz/144 Hz (C27G7*T* /
C32G7*T*), 120 Hz (C49G9*T*).
―
If the PC has entered BIOS mode and the BIOS screen does not appear, go to the following path and then
select the mode.
→
System
→
DisplayPort Ver.
→
1.1
or
1.2
.
―
The DisplayPort Ver. option is disabled if
Adaptive-Sync
is set to
On
and there is a signal input.
―
C49G9*T* model only.
Input Port Ver.
Select an HDMI version.
―
The supportable device and resolution may differ depending on its version.
―
When the version is changed, the screen may blink.
―
If you set the
HDMI Mode
to
1.4
, some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
―
When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
―
Set
HDMI Mode
to
1.4
if the monitor is connected to an HDMI device and the monitor does not display the
screen properly, displays a blank screen, or does not play sound at all.
Auto Source Switch
By activating, a new connected source is displayed automatically.
―
This function may not be supported depending on the model or geographical area.
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration
,
1 sec
, or
2 sec
can be selected. If
No Repeat
is selected, a command responds only once
when a button is pressed.
Power LED On
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working
: The power LED is on when the product is turned on.
•
Stand-by
: The power LED is on when the product is turned off.
