33
Using "HUB Monitor"
2
2 Using "HUB Monitor"
3
Right-click on the HUB Monitor’s network device (marked “LAN9512/LAN9514 USB 2.0 to Ethernet
10/100 Adapter #7”), and select
Use
.
Be sure to perform this process before configuring the IP.
4
Configure the static IP. Assign the static IP that is allotted to the HUB Monitor’s network device.
Go to
Control Panel
Network and Internet
Network and Sharing Center
Change
adapter settings. Next, right-click on the HUB Monitor’s network device (marked “LAN9512/
LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”), select
Properties
Internet Protocol
Version 4 (TCP/IPv4)
Properties, and configure the static IP and DNS settings
.
5
After configuring the IP, click
OK
. The following message will appear.
A static IP must be allotted to only one network device. The following message will appear if the
same static IP is allotted to the network devices of both the notebook PC and HUB Monitor.
(Ensure the network device that is not in use is set to
Disable
.)
Select
No
in the message window.
To use the notebook PC’s LAN network, set the HUB Monitor’s network to
Disable
and the
notebook PC’s network device to
Use
. Next, configure the IP settings.
→
→
→
→
→
