INST
ALLA
TION INSTR
UCTIONS
31
INSTALLING THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line
1) Turn on the main water supply & shut-off valve of the water
supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
NOTE
2) When you press the test button, the ice cube container is
filled with water from the water supply tap.
Check the amount of water (see the illustration below).
If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker
but of the water pressure in
the pipe, and occurs frequently.
When this problem occurs, contact
the dealer service center to check the
amount of water supplied.
Check the amount of water supplied to the ice tray.
CHECK THE WATER
LEVEL
TEST BUTTON
TOO HIGH
OPTIMUM-
LEVEL
1) Lift up (
①
) and pull out (
➁
) the ice maker bucket in the freezer.
ICE MAKER
TOO LOW
WATER
ICE
Epel pjt IB-01453B-EN (0.1) 4/15/05 1:17 PM Page 31
