Samsung AX60R5080WD/EU, User Manual

Page: 10 / 18

9 English
Checking the air quality
You can review the current air quality from the display panel with
the colour (reflecting the PM10 / PM2.5 / PM1.0 / gas pollution)
and the concentration level indicators.
• Each time you press the Air quality [ ] button, the current
state is displayed in the order of PM10 → PM2.5 → PM1.0. The
PM2.5 and PM1.0 levels are displayed for 10 seconds, before
automatically changes to the PM10 level.
‐ The air quality will be ‘Very Poor’ when the PM2.5 / PM1.0
levels are worse than the PM10 level.
If the concentration levels are same for all PM groups, the
indicator will reflect the PM10 level.
• Air quality levels
Pollution level
PM10
concentration
( ㎍ /m³)
PM2.5 / PM1.0
concentration
( ㎍ /m³)
Gas pollution
level
Very poor Red 151 and over 76 and over 4
Poor Yellow 81 - 150 36 - 75 3
Moderate Green 31 - 80 16 - 35 2
Good Blue 30 and below 15 and below 1
‐ PM10, PM2.5 and PM1.0 measurement will be displayed in
numbers 05 – 999.
Checking before Use of Filter
• If you operate the air purifier with no filter, its purification effect decreases.
• At the initial stage of use, new filters may smell bad a little.
‐ If you operate it for a day, the smell disappears.
• If you operate the air purifier after 2 weeks or more or bad odour comes out, set the fan speed to High and
run the air purification for at least 4 hours while ventilating the area.
• Close windows and doors during operation. Periodically ventilate the air to avoid high concentration of
carbon dioxide when the room is closed for a long time.
• The cycles for filter cleaning and replacement may differ depending on the environment. You are charged
for the service.
• The indicator illuminates to notify when the filters need to be replaced.
However, if the filters are too dirty or smells bad or the fan speed is lowered rapidly, replace them with
new ones even if the indicator does not illuminate.
• In case of first use or replacement, be sure to remove the vinyl from filters.
10 / 18