2 Remove the screw located at the lower section of the front grille.
It is secured in the section depending on the model.
E-
21
Rubber cap
Screws(2EA)
Gasket
Rear
Drain Tube
Installation of the Drain Tube
Fix the drain tube as shown in the figure.
Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the
condition of the installing area.
1 Open the front grille; refer to page 1
6
.
3 Remove the front panel.
4 Remove two screws on the lower, right and left sides of the unit.
Example: High storage
In the case of an area where the drain pan can not be directly
installed on the rear side of the unit after installing the air conditioner.
3-1 Press both sides of the cabinet in the directionof the arrow
as shown in the figure.
3-2 Pull the lower part of the front panel slightly forward.
(below three inches)
3-3 Lift the front panel upward.
Applying excessive force to remove the front panel
may cause damage to the tab; be sure not to use
excessive force.
In some region, drain tube and drain pan may not be supplied.
Plesae contact the sales agent.
5 Remove the chassis from the cabinet.
6 Remove the rubber cap inserted into the basepan.
7 Fix the drain pan as shown in the figure, and then connect the drain hose.
(You can use any commercially-available drain hose.)
8 Install the cabinet at the specified area after installing the drain pan,
and then re-assemble it in the original condition.
1 Follow steps 6 and 7 only
In the case of an area where the drain pan can be directly installed
on the rear side of the unit after installing the air conditioner.
Secure the front panel to the case by replacing the screw removed in
step 2. If a screw not removed in setp 2, secure the panel with a
supplied screw.
Rear
Screw
Drain Pan
Rubber cap
Drain Hose
Bottom-Side View with
Drain Pan and Hose in Place
H
SI
L
G
N
E
