18
Indoor Unit Installation
English
Installation
4
Using a crimping tool, compress the two points and flip it
over and compress another two points in the same location.
࡛
The compression dimension should be 8.0.
Compression
dimension
࡛
After compressing it, pull both sides of the wire to
make sure it is firmly pressed.
Compress it 4 times
0.20inch(5 mm)
Method 1
Method 2
Compress it 4 times
0.20inch(5 mm)
5
Wrap it with the insulation tape twice or more and position
your contraction tube in the middle of the insulation tape.
1.57inch(40 mm)
Insulation tape
Method 1
1.37inch(35 mm)
Insulation tape
Method 2
6
Apply heat to the contraction tube to contract it.
Contraction tube
Method 1
Contraction tube
Method 2
7
After tube contraction work is completed, wrap it with the
insulation tape to finish.
Three or more layers of insulation are required.
Insulation tape
Method 1
Insulation tape
Method 2
CAUTION
࡛
Make sure that the connection parts are not exposed
to outside.
࡛
Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials
that have the same level of withstand voltage with
the power cable. (Comply with the local regulations on
extensions.)
WARNING
࡛
In case of extending the electric wire, please DO NOT use
a round-shaped Pressing socket.
ࣞ
Incomplete wire connections can cause electric
shock or a fire.
Step 2-6 Connecting the drain hose
1
In Step 2-3, step 3 you determined the exit position for the
piping bundle. If using the right, bottom, or right rear exit,
change the drain hose connection from the right to the
left so that the drain hose will lie along the inside of the
unit and exit to the right.
Drain pan outlet
Rubber cap
Summary of Contents for AR TSFA Series
Page 28: ......
