E-
4
Deciding the Installation Place
You should observe the following restrictions when you decide the installation place.
General
Do NOT install the air conditioner under the following conditions;
◆
Combustible gases
◆
Saline air
◆
Machine oil
◆
Sulfide gas
◆
Special environmental conditions
If you have no alternative place to install it, first consult your dealer or a qualified person.
Indoor Unit
◆
There must be no obstacles near the air inlet and outlet.
◆
Install the indoor unit on a surface that can support its weight.
◆
Choose a place where you can easily connect the pipes and cables to the outdoor unit.
The recommended length of the pipes and cables is 5 meters. The maximum length is ‘L’ meters.
◆
Leave sufficient space below the indoor unit to remove the filters easily.
◆
Maintain sufficient space around the indoor unit as seen in the picture on page 5.
◆
Make sure that the water dripping from the drain hose runs off correctly and safely.
◆
Install the indoor unit higher than 2.5m from the ground.
Outdoor Unit
◆
NEVER place the outdoor unit on its side or upside down. The compressor lubricating oil may run into the circuit and
damage the outdoor unit seriously.
◆
Choose a dry and sunny place avoiding direct sunlight or strong winds.
◆
Do not obstruct the passage.
◆
Avoid a place that may disturb your neighbor. A noise may occur from the outdoor unit and the discharged air may
run into the neighborhood.
◆
Choose a place where you can easily connect the pipes and cables to the indoor unit. The recommended length of
the pipes and cables is 5 meters. The maximum length is ‘L’ meters.
◆
Install the outdoor unit on a flat and stable surface. Otherwise it may slant and make some noise and vibration.
◆
Install the outdoor unit on a hard and even place that can support its weight.
◆
Place the outdoor unit so as to let the discharged air out properly.
◆
Maintain sufficient space around the outdoor unit as seen in the picture on page 5.
◆
When you install the outdoor unit at a height, you should firmly fix it in its place. The maximum height is ‘H’ meters.
◆
Make sure that the water dripping from the drain hose runs off correctly and safely.
◆
The air conditioner must be installed according to the national electrical rules.
◆
Max input power & current is measured according to IEC standard and input power &
current is measured according to ISO standard.
C
C
C
C
A
A
A
A
U
U
U
U
T
T
T
T
II
II
O
O
O
O
N
N
N
N
P
REPARING THE
I
NSTALLATION
AQT18WJWB IM_E_20227 10/25/04 1:34 PM Page 4
