32
Installation Procedure
Ins
tallation Pr
oc
edur
e
English
3
Check whether the option values that you have set are
correct by pressing the
(Mode) button repeatedly
[SEG2, SEG3]
[SEG11, SEG12]
[SEG21, SEG22]
[SEG4, SEG5]
[SEG14, SEG15]
[SEG23, SEG24]
[SEG6, SEG8]
[SEG16, SEG17]
[SEG9, SEG10]
[SEG18, SEG20]
4
Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
(Power)
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it
is successfully received, you can hear a short sound
from the indoor unit. If the command is not received,
press the
(Power) button again.
5
Check whether the air conditioner operates in
accordance with the option values you have set:
a
Reset the indoor unit by disconnecting and then
reconnecting the power cable of the indoor unit
or by pressing the RESET button on the outdoor
unit.
b
Remove the batteries from the remote control,
insert them again, and then press the
(Power)
button on the remote control.
Setting the indoor unit addresses
Option No. for an indoor unit address:
0AXXXX-1XXXXX-2XXXXX-3XXXXX
Before installing an indoor unit, be sure to set an address
for the indoor unit by taking the following steps:
1
Make sure that the power is supplied to the indoor
unit. If the indoor unit is not plugged in, it must
include a power supply.
Indoor unit
F1
F2
L
N
2
Make sure that the panel is connected to the indoor
unit so that it can receive options.
3
Set an address for each indoor unit using the remote
control, according to your air conditioning system
plan, by referring to the following table and by
following the steps in
Common steps for setting the
addresses and options
on page
21
.
•
The indoor unit addresses (main and RMC
addresses) are set to 0A0000-100000-200000-
300000 by default.
•
If indoor units and outdoor units match 1:1, you
don’t need to set the addresses.
•
The main address of each indoor unit is set
automatically. However, you can set the main
address manually if the relevant outdoor option is
set to MANUAL ADDRESS.
Steps
Remote control display
b
Set the SEG24 value by pressing the
(High Fan) button repeatedly until the
value you want to set appears on the remote control display.
When you press the
(Low Fan) or
(High Fan) button, values appear in the
following order:
SEG24
360_AC_Indoor_IM_NA_Eng_EN.indb 32
2016-03-18 오후 3:59:15