Action 3
When temperature inside
of the projector becomes
too high.
installation precautions listed above. Cool down your projector
sufficiently and then operate it again. If the same problem occurs
continually, contact your product distributor or
service center
.
Action 4
When the DDP IC or color wheel
fails to operate.
Disconnect and reconnect the power cord and start the projector
again. If the same symptom still occurs, contact your product
distributor or
service center
.
Action 5
The lamp is
malfunctioning after
abnormal power off or
restarting right after
turning off the projector.
Turn the power off, wait for a sufficient amount of cooling time and
then turn the power on for operations. If the same problem occurs
continually, contact your product distributor or
service center
.
Action 6
When the screen becomes
darker
Check the lamp usage time on the Information Display screen. If you
need to replace the lamp, contact your product distributor or
service
center
.
This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may
cause noise, which does not affect the product performance. No exchange or refund for the noise concern.
Rear Side
1. PC IN Input port
2. COMPONENT IN Input port
3. S-VIDEO IN Input port
4. POWER Input port
5. RS-232C port
(For service input terminals)
6. VIDEO IN Input port
7. Remote Control Signal Receiver
8. HDMI IN 2, HDMI 1/DVI IN Input port
Summary of Contents for A800
Page 1: ......