6
The MediaOne M50 main input connections can be made via the rear panel
RCA inputs. Follow the simple steps and diagram below for connecting an
audio source to the speakers.
1.
Connect the left and right speakers using the included two-conductor,
1/8” (3.5mm) speaker cable.
2.
Turn the MediaOne M50 Volume control completely counter-clockwise
until it clicks to the minimum/off setting.
3.
Connect the MediaOne M50 to an AC power outlet using the included
power cable.
4.
Connect the audio output from your audio source such as a computer or
portable audio device to the RCA or 1/8” (3,5m) inputs of the MediaOne
M50 right side speaker.
5.
Turn the Volume control clockwise until it clicks to turn the MediaOne
M50 speakers on. The front panel Power Indicator will light white.
6.
Play music from your audio source and slowly raise the volume of the
MediaOne M50 to a comfortable listening level.
Note: Before plugging in and turning on, remember the “last on, first off”
rule of powered speakers. When powering up your system, be sure that all the
wires are connected, turn your mixer and any other outboard gear on, and then
last turn on your MediaOne M50. When powering down, turn your MediaOne
M50 off first and then your mixer and outboard gear.
Standby Mode
In order to save power, the MediaOne M50 speakers will go into Standby
mode when no signal is preset at any time for longer than 5 minutes. The
front panel Power Indicator will turn off, even with Power Switch in the On
position. The speakers will automatically wake up when you pass signal
through the inputs.
Quick Start
