6
Guided Tour - UR1 Rear Panel
1: DC input - Connect the supplied 12 volt 160 mA power adapter here, using the strain
relief as shown in the illustration below. WARNING: Do not substitute any other kind of
power adapter; doing so can cause severe damage to the UR1 and will void your warranty.
2: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the UR1 to consumer (-10) audio equipment. Wiring is as follows: tip hot,
sleeve ground.
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced
output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the “Setting Up
and Using the Series One System” section on page 8 in this manual for more information.
4: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR
jack when connecting the UR1 to professional (+4) audio equipment. Pin wiring is as
follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
* If required, both the unbalanced and balanced outputs can be used simultaneously.
UHF Series One Frequency Conversion Chart
Channel
Frequency
U1
801.375 MHz
U2
801.875 MHz
U3
803.125 MHz
U4
803.750 MHz
U5
804.500 MHz
U6
804.750 MHz
UNBALANCED
OUTPUT
BALANCED SWITCH
BALANCED OUTPUT
XLR:
1 GND
2 HOT
3 COLD
LINE:
-20dBm600
Ω
MIC:
-40dBm600
Ω
MIC
LINE
POWER RATING
DC 12V, 1.9W(160mA)
-10dB 5K
Ω
DC INPUT
1
2
3
4
+
-
A
C
CABLE LOCK
CAUTION:
USE SAMSON
AC ADAPTOR
ONLY
CABLE LOCK: LOOP THRU AND TIE
-
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
ENGLISH