If you’ve had some prior experience using wireless systems, these QuickStart
instructions will get you up and running with your AirLine UHF wireless system in a
matter of minutes! Detailed instructions for setting up and using your AirLine Synth
system can be found on page 15 of this manual, and the “Guided Tour” sections on
pages 10 - 14 provide full descriptions of all AirLine component controls and displays.
1. Unpack the AR300 receiver and AL300
transmitter and configure SE10 earset or
LM10 lavaliere into the AL300’s mini XLR
input connector.
2. Physically place the AR300 receiver next to
your mixer. Extend its antennas vertically
and spread the tips horizontally outwards.
3. Set the power switch on your AL300
transmitter to the “off” position (away
from the arrow) and install two fresh
AAA alkaline battery in the battery
compartment, being sure to observe
the polarity markings. Then turn the
transmitter back on momentarily; its
LED will flash once and then go off if the
battery is sufficiently strong. Once battery
strength is verified, turn the transmitter off
again, then put it aside for now.
4. Connect the included AC power supply
to the rear of the AR300 and then to an available wall socket. Turn the AR300 on
momentarily to confirm that the unit has power. Then turn the AR300 power off.
5. Turn your mixer off and make the physical cable connection between an audio input
and the AR300 output jack.
6. Turn the Level knob on the AR300 completely counterclockwise, then turn its power
on.
QuickStart
319
2