62
Guida rapida
Accendere l'alimentazione del
trasmettitore facendo scorrere
l'apposito interruttore Power
verso sinistra.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver
4. Turn on receiver
5. Plug receiver into audio system
6. Press Select button to change channel
9. Press and hold SELECT button to IR set
10. Adjust Volume control
7. Install batteries
8. Press button on transmitter to turn on
9. Press and hold Select button to IR set
7. Install batteries
8. Turn on belt pack transmitter
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver
4. Turn on receiver
5. Plug receiver into audio system
6. Press Select button to change channel
9. Press and hold SELECT button to IR set
10. Adjust Volume control
7. Install batteries
8. Press button on transmitter to turn on
9. Press and hold Select button to IR set
7. Install batteries
8. Turn on belt pack transmitter
Posizionare il trasmettitore AG8 a circa 15–30 cm (6–12”) dalla parte anteriore del CR88 con la
lente IR del trasmettitore rivolta verso il trasmettitore IR situato sul pannello anteriore del ricevitore
CR88.
Tenere premuto il pulsante SELECT del CR88 per impostare il trasmettitore sullo stesso canale del
ricevitore tramite trasmissione a infrarossi. Mentre il ricevitore invia il canale operativo, il display
del CR88 lampeggia.
Premere il tasto SELECT sulla parte anteriore del ricevitore
CR88 per scegliere un canale disponibile. Il numero di canale
aumenta di una cifra, da 0-9 quindi A-F. Una volta raggiunto
l'ultimo canale, il conteggio ritorna a 0.
Nota bene: L'AG8 accetterà la trasmissione a infrarossi dal ricevitore unicamente
per i primi 10 secondi dall'accensione dell'AG8. Se si desidera cambiare il canale
operativo, l'AG8 deve innanzitutto essere spento, quindi riacceso per ricevere il
nuovo canale.
Summary of Contents for Airline 88
Page 1: ...OWNER S MANUAL...
