Samson 4747, Mounting And Operating Instructions

Page: 21 / 64

EB 4747 EN 21
Measures for preparation
4 Measures for preparation
After receiving the shipment, proceed as
follows:
1.
Check the scope of delivery. Compare
the shipment received with the delivery
note.
2. Check the shipment for transportation
damage. Report any transportation dam
-
age.
4.1 Unpacking
Do not remove the packaging if the limit
switch is to be transported to another loca-
tion or kept in storage.
Before mounting the limit switch, proceed as
follows:
1.
Remove the packaging from the limit
switch.
2. Dispose of the packaging in accordance
with the valid regulations.
4.2 Transporting
Î
Pack the limit switch properly to comply
with terms of transportation.
Transport instructions
− Protect the limit switch against external
influences (e.g. impact).
− Protect the limit switch against moisture
and dirt.
− Observe transport temperature depend-
ing on the permissible ambient tempera-
ture (see technical data in section 3.5).
4.3 Storage
Risk of damage to the limit switch due to
improper storage.
Observe the storage instructions. Contact
SAMSON, if need be.
Storage instructions
− Protect the limit switch against external
influences (e.g. impact, shocks, vibra -
tion).
− Do not damage the corrosion protection
(coating).
− Protect the limit switch against moisture
and dirt. In damp spaces, prevent con-
densation. If necessary, use a drying
agent or heating.
− Observe storage temperature depending
on the permissible ambient temperature
(see technical data in section 3.5).
5 Mounting
The limit switch is suitable for the following
types of attachment:
− Direct attachment to SAMSON
Type 3277 Actuator
− Attachment to actuators according to
IEC 60534-6 (NAMUR rib)
− Attachment to Type 3510 Micro-flow
Valve
− Attachment according to VDI/VDE 3845
to rotary actuators
Note
NOTICE !