Samson 3725 series, Mounting And Operating Instructions

Page: 53 / 68

EB 8394 EN 53
Code list
P15 Start initialization
Press button to cancel the initialization process. As a result, the
valve moves to the fail-safe position. After a power supply failure
during initialization, the positioner starts with the values of the last
initialization (if available).
P16 Start zero calibration
The zero calibration process can be interrupted by touching .
The control valve returns to closed-loop operation.
Note: A zero calibration cannot be started when E1 error code ex -
ists.
After a power supply failure during zero calibration, the positioner
starts with the settings from the last zero calibration.
P17 Manual mode
Press or to enter the set point.
P18 Reset Parameters are reset to their default setting.
The positioner can only return to closed-loop operation after it has
been re-initialized.
P19 Enable configuration
[LOCK]/OPEN
Enable configuration to change parameter settings.
This function is automatically canceled when none of the keys are
touched within three minutes.
P20 Firmware version
Installed firmware version is displayed. Touch to display the last
four digits of the serial number.