Samson 3375, Mounting And Operating Instructions

Page: 23 / 130

EB 8332-2 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
4.2 Removing the packaging
from the actuator
Do not remove the packaging until immedi -
ately before mounting and start-up.
1. Remove the packaging from the electric
actuator.
2. Check scope of delivery (see Fig. 4-1).
3. Dispose of the packaging in accordance
with the valid regulations.
Note
1x Type 3375-xx Electric Actuator
1x Document IP 8332-2
(Important Product Information)
for Types 3375-10, -20, -22, -30:
1x Accessory 0900-2679, consisting of
2x Stem connector for
Ø 16 mm stem
2x M6 screw
1x M30x1.5 ring nut
for Types 3375-11, -21, -31:
1x Accessory 1400-9565, consisting of
2x Stem connector for
Ø 22 mm stem
2x M12 screw
1x M60x1.5 ring nut
Fig. 4-1: Scope of delivery
4.3 Transporting the actuator
− Protect the actuator against external in-
fluences (e.g. impact).
− Protect the actuator against moisture and
dirt.
− Observe the permissible transportation
temperature of –20 to +70 °C.
4.4 Lifting the actuator
− Use suitable equipment to lift the actua-
tor.