www.larius.com
3
ED. 08 - 05/2020 - Cod. 150093
GHIBLI 26:1 EXT
B
C
WOrKING prINCIpLE
GHIBLI 26:1 DE
is a high pressure pneumatic pump used for
extrusion and transferring of high viscosity products.
The pump is essentially constituted of an air motor and of a
structure called "material pumping group" or simply "pumping
group".
In the pneumatic motor, compressed air causes the vertical
reciprocating movement of the motor piston; this movement
is transmitted through a connecting rod to the material pum-
ping piston ending with a shovel plate alowing to suck very
viscous products.
The ratio 26:1 means that the outlet pressure of material is 26
times higher than the pump feed air pressure.
TECHNICaL DaTa
parts of the pump in contact with the material
Pumping group: galvanized carbon steel
Sealing balls: stainless steel AISI 420B
Gaskets: PTFE, Viton
Other parts of the pump
Motor casing and motor piston: aluminium
GHIBLI 26:1
Pump feed air pressurea
3-7 bar
Maximum pressure of the product
182 bar
*Feed air inlet
BSP 1/2 (F)
Maximum delivery
4 l/m (6,4 cpm)
Cycles per litre
15
Maximum cycles per minute
60
Material outlet [conical gas(f)]
BSP 1/2 (M)
Noise pressure level
<80 dB (A)
always observe these instructions carefully
when evaluating the product compatibility and
in case of disposal of some parts of the pump no
more usable, in order to meet the environmental
regulations on recycling process.
*N.B.
The pump is supplied with a bayonet connection.
