www.larius.com
24
ED. 08 - 05/2020 - Cod. 150093
GHIBLI 26:1 EXT
24
N1
N2
N
Fig. 1N
Procedure
24.1
Reassemble the shovel plate
Necessary tools and equipment
MaNUaL rEsET OF THE pNEUMaTIC MOTOr
• The feed air pressure of the pump must never be higher than
the maximum value indicated in the technical data. Exceed
this value can block the valves of the pneumatic motor in
the intermediate position of the cycle reversal.
• To start again a blocked motor, close the air supply and
release pressure in the plant. This operation should allow
the recovery of the valves.
• In case the motor is blocked, proceed as follows:
- unscrew the motor cap (
N1
) and pull it upward along with the
guide rod (
N2
) so as to manually trigger the stroke inversion
unit;
- screw again the plug.
Close the air supply to the pump and release the
residual pressure in the plant.
