Index revision : H
10
6336
4. Operation
The
Mach-Jet
spray gun is connected to the
CRN 457
control module via a serial link embedded in the
electrical connection cable. This link enables recognition of the spray gun and the exchange of data
necessary for operation.
Methods for modifying or adjusting settings are described in the following chapters. It is possible to return
to the original “factory” settings at any time (
In the case of a manual unit not connected to an industrial PLC
:
The first time the control module is started up, the operator selects the operating mode for powder feed;
two possibilities are proposed:
• Use of a vibrating table (factory parameter).
• Use of a round fluidisation tank.
WARNING : This use parameter can then be modified at any time in the “F” menu displayed on
the control module.
F
1
