SAMES KREMLIN
Page 9
Manual : 573.182.112
PARTIAL FLUSHING (STAGE 3)
If the working shutdown lasts longer than the
material "working life", carry out a PARTIAL
flushing.
The FLUSHING stage enables to flush the
BASE circuit and the mixed material.
Move the valve (20) hand lever to supply the
BASE fluid section with solvent.
Position the valve (11) hand lever vertically.
Connect the air tube on the hole on the far left
of the plate (opening of the CTM valve
towards the container B
⇒
circulation of the
catalyst).
Screw the black regulator 'Pump Pressure'
until pump begins to start (pressure : from 1
to 2 bar / from 14.5 to 29 psi).
The solvent S and the cata B are drawn and
delivered via their respective fluid section.
Each material comes to the manifold valves :
the CATA is sent to the container, the solvent
passes through the manifold, the mixer and
comes to the gun.
Remove aircap and tip from the gun and
clean them carefully.
Point and trigger the gun into a waster
receptacle.
When clean solvent flows out, the circuit is
flushed.
Leave the equipment until a next utilization
A
A
S
B
20
11
12
3
6. ADJUSTMENTS
TROUBLE
CAUSE
SOLUTION
Coating not thick enough
Not enough material
Increase the material fluid
pressure using black knob.
Spray slower or closer to part
being painted.
Use the next higher nozzle
size.
Sags, runs
Too much material
Decrease the material
pressure using black knob.
Spray faster or farther from
part being painted.
Use the next smaller size.
Distorted spray fan
Refer to gun instruction manual
