Doc.-ID: 220815-PT10BA-ES-RoughCam IPM2036_en_rev.00.docx, Page 26 of 28
If it is not possible to assign the IP address, it might be necessary to
change the firewall settings!
The “AXIS IP Utility“ tool automatically recognizes all RoughCam devices and visualises
them in the device list. It can also be used to manually assign a static IP address. For this
purpose, the RoughCam IPM2036 network camera has to be installed in the same physi-
cal network segment (physical subnet) as the computer on which the AXIS IP Utility is
running. The network signature of RoughCam IPM2036 is "AXIS M2036-LE" (see Figure
7-1). MAC address and serial number for clear device identification are also detected and
displayed.
Figure 7-1 Axis IP Utility
7.3
Password/ Identification
The following user name is set at the factory:
root
The following password is set at the factory:
root
8
Maintenance / Modification
The required maintenance intervals are specific to the individual devices. The operating
company has to determine these intervals depending on the application parameters. If
maintenance measures are necessary they have to be initiated and/or executed.
Repairs may only be carried out with original parts of SAMCON Prozessleittechnik
GmbH. In case of doubt, send the part in question back to SAMCON Prozessleittechnik
GmbH. Rebuilding of or alterations to the devices are not permitted.
RoughCam IPM2036
