SaMASZ PT3 190, Operator'S Manual

Page: 8 / 28

8
PT CIRCULAR SAW OPERATOR ’ S MANUAL
4.1.2. Transport
❑
When driving on public roads always respect the local traffic regulations concerning warning lights.
❑
When approaching transportation of the aggregation of the arm and the circular saw, take off or
partially disconnect PTO shaft from the tractor’s side.
❑
Prior to the transport protect circular blades with an additional protective guard.
❑
When transported the arm-saw aggregate shall have mobile warning light device and warning
triangle mounted for a slow driving vehicle.
❑
When transported the machine should always be set in transport position. See Fig. 6 .
❑
Any modifications in the circular saw's position are possible only if no vehicles or unauthorized
personnel are around (children in particular).
❑
Driving speed should always be adjusted to current road conditions.
❑
Do not exceed permissible speed of 25 km/h.
4.1.3. Transport and delivery
Both carrier and driver are responsible for machine transportation. All equipment and parts must
be secured for transport. In order to move the machine onto any other means of transport follow the
below rules.
❑
When hoisting do seize the points indicated for this purpose on the machine and labeled with a
hook symbol (
Fig. 4 ) only,
Fig. 4. Manner of lifting saw when moving
❑
For hoisting do use hoists with capacity bigger than the circular saw's weight as indicated on its
data plate. It also applies to the necessary cables and chains,
❑
Transport belts, belt suspensions, ropes cannot be damaged. Whenever damages to these parts are
found, replace these with new ones,
❑
When mounting slings, chains, clamps, etc. always keep in mind the centre of gravity of the machine
(
Fig. 5 ) ,
❑
For seizing the machines pick lines of adequate length, so that the angle between them was no
greater than 120°, and the angle of inclination between the cable and the vertical was no greater
than 60°,
❑
collapsible elements should be locked in transport position,
❑
when relocating the machine onto another vehicle, there should be no unauthorized personnel
permitted to remain within the danger area,
❑
The machine should be protected from shifting on the vehicle's trailer.