Sam4s SPS-500, Service Manual

Page: 67 / 184

3 Installation and Operation
3-44 SAM4S SPS-500 Series
3-13 Installation
3-13-5 Take-Up Spool Installation
1. Before using the PRINTER(JOURNAL). Install the TAKE-UP SPOOL as described in the figure.
2. Push the ORANGE CAP LEVER towards the rear of the PRINTER and lift up to open the
PRINTER COVER.
3. Unroll the paper about 400mm.
4. Ensure that the paper is being fed from the bottom of the roll.
5. Place the roll into the concave bottom of the PRINTER as shown in Figure3-3-
①
.
6. Put the leading edge of the paper over the PRINTER as shown in Figure3-3-
①
.
7. Close the PRINTER COVER.
8. Fold the end of the thermal paper about 20mm in length. Slide the leading end of the folded paper
into the groove on the TAKE-UP SPOOL and wind it onto the SPOOL two or three turns as
illustrated Figure3-3-
②
.
9. Put the removed GUIDE WINDING into the end of the TAKE-UP SPOOL WINDING and fix the removed
GUIDE WINDING in the direction as shown in Figure3-3-
③
.
10. Place the TAKE-UP SPOOL into the HOLDER SPOOL behind the PRINTER(JOURNAL) above the roll
paper as illustrated Figure3-3-
④
.
11. If the paper is loose, rewind the TAKE-UP SPOOL to tighten the paper.
Figure 3-3 Paper & Spool Installation