IQFDA31
Operation Using the RollCall Control Panel
Issue 1 Rev 1
Page 24
© 2016 SAM
5.8 SFP Setup
The SFP Setup screen displays basic information about the SFP configuration. If the SFP is
not recognized, manual configuration is available.
5.8.1 Restart
The
Restart
button enables the module to be rebooted, simulating a power-down/power-up
cycle.
5.8.2 Configure Type
In the event of the module not recognizing the SFP, the
Configure Type
controls will become
available for manual selection.
Note:
The SFP Setup screen is only displayed when the module is fitted with a rear that supports
SFPs, even if no SFP is fitted.
Note:
When changing an SFP, the module needs to be restarted in order for the SFP to become
active.
Before configuring the SFP, ensure that the correct SFP is installed.