en
Procedure in the event of alarms
Personnel:
□ Operating
personnel
1.
Switch on the device at the mains power switch.
2.
Unplug the mains plug.
3.
Eliminate the cause of the fault; for example, fill with water
up to at least the MIN marking.
4.
Press the reset button on the rear side of the control panel
to reset the alarm. Use a toothpick or similar for this.
The alarm has been reset.
The reset button can be found on the rear side of the device
5.
Plug in the mains plug again and switch on the device
again at the mains power switch.
The device operates again.
Procedure in the event of errors
Personnel:
□ Operating
personnel
1.
In the case of an error, switch off the device at the mains
power switch.
2.
Switch on the device again at the mains power switch.
If the error occurs again after restarting the device, note the
error code and contact the authorized customer service.
Errors are symbolised with an "E" and a sequential three-digit
number.
Summary of Contents for 883844
Page 86: ...86 88 ...
Page 87: ...87 88 ...
