Salutron SRT5000, Instruction Manual

Page: 10 / 16

10
5.4 Measuring
When all parameters are set and the protector is open one
can start measuring. Point the Stylus mark to the
measured area and press the start button on the top of the
gauge. After hearing a signal, the measurement has been
finished and the screen will show the measured value.
Note:
1) During the pickups movement, make sure that the
tester stands stable on the measured surface to
avoid measurement errors.
2) During the sensors return to its starting position, the
tester will not respond to further actions.
3) After a measurement has been taken it is possible to
display the value according to all other
measurement methods (Ra, Rz, Rq, Rt) by pressing
.
Note that this conversion is not very accurate. For
precise values one has to set the corresponding
measurement method before measuring.