Specification:
Package Content:
Protocol: Z-Wave™ (ZS6101N) 1pc ZS 6101 smoke detector
Frequency Range:
1pc Bracket Holder
868.42MHz (ZS6101EU)
2pcs Plastic Anchor & Screws
908.42MHz (ZS6101US)
1pc CR123A Lithium Battery
921.42MHz (ZS6101AU)
1pc
Installation & Operation
manual
Operating Range
Up to 100 feet line of sight
Operating Temp.
-10°C~ 50°C (14°F ~122°F)
Battery
Panasonic CR123A * 1PC
Note: If you are installing the entire Z-Wave TM system for the first time,
please refer to the installation guide of Z-Wave TM Interface Controller before
installing ZS6101.
For “Inclusion” in (adding to): Put the Z-Wave TM Interface Controller into
“inclusion” mode, and following its instruction to add the ZS6101 to your
controller. To get in the “inclusion” mode, the distance between sensor and
controller is suggested to be in one meter. Press the program switch of
ZS6101 for 1 second at least to be included.
For “Exclusion” from (removing from) a network: Put the Z-Wave TM Interface
Controller into “exclusion” mode, and following its instruction to delete the
ZS6101 to your controller. Press the program switch of ZS6101 once to be
excluded. Please note: The LED on the ZS6101 will flash (red) continuously in
Exclusion mode.
For “Awake” mode : it is to leave the “Sleep” mode by pressing the program
switch for 1 second at least to allow the Z-Wave TM Interface Controller to do
“inclusion”, “exclusion”, “Association” and to reply and receive the commands
from controller. It will take about 5 seconds and the red LED light on for
awaking the system. LED light will be off after setting.
