Pump logic module for KL06 wiring centre
Model: PL06
[EN] XI 2018
Importer:
SALUS Controls plc
Salus House, Dodworth Business Park
Whinby Road, Barnsley S75 3SP,
United Kingdom
www.salus-controls.com
SALUS Controls is a member of the Computime Group.
Maintaining a policy of continuous product development SALUS
Controls plc reserve the right to change specification, design
and materials of products listed in this brochure without prior notice.
Introduction
Technical Information
Power Supply
from the KL06 wiring centre
Max load
5 (2) A
Output
NO/COM/NC relay
Dimensions [mm]
60 x 80 x 20
PL06 module extend a functionality of KL06 wiring centre.
Module is used to control the pump (or boiler) using volt-free
NC/COM/NO contacts. When any of thermostats connected to the
KL06 230 V reports heat demand, COM/NO contacts are closing.
COM/NO contacts are opening, when thermostats connected
to the wiring centre will stop sending signal for heating.
Product Compliance
This product complies with the essential requirements and
other relevant provisions of the following EU Directives: EMC
2014/30/EU, Low Voltage Directive LVD 2014/35/EU, RoHS
directive 2011/65/EU. The full text of the EU Declaration of
Conformity is available at the following internet address:
www.saluslegal.com.
Safety information
Use in accordance to national and EU regulations. Use the device
as intended, keeping it in dry condition. Product for indoor use
only. Installation must be carried out by a qualified person in
accordance to national and EU regulations.
Before any of operation releated to power supply (connecting
wires, installing the device, etc.), make sure that devices is not
connected to any power source. Installation must be carried out
by a qualified person. Incorrect connection of the wires may
cause damage to the wiring centre. The module can not be
used in conditions of water vapor condensation neither exposed
to water.
Serial connector for PL06 and PL07 modules
It provides communication between the KL06 wiring centre and
the PL06 module. KL06 wiring PL06 module increases
functionality and additionally makes possible to control pump
or boiler. PL06 module is powered from the wiring centre.
ON OFF
3
4
Delay
Overrun
ON OFF
1
2
1
2
3
4
5
6
fuse
(T2A)
L N
L N
L N
L N
L N
L N
L
N
CON1
Manual
