Tel: 886. 909 602 109 Email: [email protected]
45
g) [Automatically create window] check box
If this check box is ticked and the number of Traces in the window exceeds 8, excessive Traces will be
automatically created in a new window.
If this check box is cleared and the number of Traces in the window exceeds 8, excessive Traces will not be created.
6.2.4 Measurement mode of Trace change
The Trace must be activated before Setup and modification.
1) Change the Trace activation status
Click the
[Trace status]
button in the window. The corresponding Trace will be activated.
Fig. 6-5 Change of Trace Activation Status
2) Change the measurement parameter of the activated Trace
Menu path:
[Response] > [Measure]
. The
measurement
sub-menu will appear. Or, right-click the Trace title bar,
and click
[Measure]
in the menu, as shown in Fig. 6-6.
Fig. 6-6 Setup of Parameter S Measurement Mode of Activated Trace
6.3
Setup of Frequency Range
Frequency range: 10MHz-13.5GHz/26.5GHz/43.5GHz/50GHz/67GHz
Frequency resolution: 1Hz
1) Two ways of frequency range Setup
a) Specify the starting and ending frequency.
b) Specify the center frequency and frequency span.
2) Setup of starting and ending frequency
Menu path:
[Stimulus] > [Freq]
Fig. 6-7 Setup of Starting and Ending Frequency