INSTALLATION
1. This appliance is designed to be free standing only, and should not
be recessed or built-in.
2. Place your appliance on a floor that is strong enough to support
the appliance when it is fully loaded. To level your appliance, adjust
the front leveling legs at the bottom of the appliance.
3. To allow proper air circulation around the wine cellar, the following are
the recommended clearances:
Sides: 3/4” (19 mm)
Top: 4” (100 mm)
Back: 2” (50 ml)
4. Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the appliance not to perform properly.
5. Avoid locating the appliance in moist areas.
6. Plug the appliance into an exclusive, properly installed-grounded wall outlet.
HOW TO USE
Setting the Temperature Control
1. Your wine cellar has an electronic temperature control on the front of
the unit. You can easily set the internal compartment temperature within
a range of 8 – 18°C (46.5 – 64.5°F).
2. When you first turn the unit on, the LCD will display the ambient room
temperature. After you select your preferred cabinet temperature on
the unit, the set temperature numerals will flash and then revert to the
original cabinet temperature. The unit will then gradually work toward
the temperature that you have set.
3. Pressing the up-arrow temperature button on the display will increase
the temperature in 1° increments and pressing the down-arrow button
will decrease the temperature in 1° increments.
4. By pressing the C/F button on the control panel, you can display the cabinet
temperature as either Celsius or Fahrenheit.
4
SAL7-569 Booklet Salton Wine Cooler WC-2030_EN VF.qxd 12/07/07 16:58 Page 4
