Lighting heater:
Before connecting the regulator to the gas cylinder, check whether there is
a rubber washer on the regulator, and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise. Turn the
gas control knob on the heater to setting 1(fig 4).
Press the control knob down and hold in the pressed condition. This will allow
gas to flow to the pilot and center burner.
While holding the control knob in the pressed position, push the piezoelectric
ignition (fig 4) button 2 or 3 tines. Each tine you strike this piezoelectric ignition
you will hear a clicking sound as well as see a spark on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed
position for a further 10 to 15 seconds thus activating the flame failure safety
device.
The pilot and center burner should remain alight.
You may now adjust the heater setting to Low/Med/High as required.
Turning off the heater:
To turn off the heater, turn the control knob to position 1 and close the gas
cylinder valve by turning the knob on the cylinder clockwise. Ensure that the
pilot flame the center burner are extinguished.
Testing gas leaks:
When you suspect that the heater is leaking, turn off the gas supply and have
the unit inspected by a qualified technician. Do not attempt to locate the source
of leak with a naked flame. Locate it by sound, smell or by applying soapy
water. Any bubbles forming will indicate the whereabouts of a leak.
Safety tips:
Do not move the heater while it is in use.
Always face the heater towards the center of the room.
Use it only in a wellventilated room. Ventilated is vital for the efficient
performance of this heater and for safety of the occupants of the room in which
it is being used. Allow plenty of fresh air in, never seal up the doorways and
windows.
Prevent young children and elderly people from touching very hot surfaces.
The normal dress guard only protects against accidental clothing contact.
Do not place clothes or other material on the heater. Keep all flammable materials
at least one meter away from the heater.
Turn off the gas valve and gas supply after its application.
Never use or store solvents and pressure pack can sans near a gas heatereven if the
heater is turned off.
Never dispose of rubbish such as cigarette butts in a gas firethis can affect
combustion and produce dangerous pollutants.
Always operate the gas control and cylinder valve from the side or rear of the
heater. Standing in front of the heater exposes you to the risk of burns
Change LPG cylinder in ample ventilated area, and from any ignition source(candle,
cigarettes and so on):