Operating Instructions:
There are 3 controls,
The first is the valve on the cylinder, which will be used to turn ON and OFF the
gas supply.
The second is the gas control knob with a dial which has 3 positions marked on it.
This control knob is located on the top end of the heater (fig 4).
The third is the piezoelectric ignition button next to the gas control knob (fig 4).
Pressing this button will generate a spark on the pilot burner thus igniting the gas
to the pilot burner.
Installation
1.
put the cylinder into the gas heater
2.
install the protection baffle to make sure the cylinder can’t move
3.
connect the pipe to the gas valve with cap (make sure no leakage)
4.
connect another side of the pipe to the regulator with cap (make sure no leakage)
5.
open the gas tap before using the heater, and close the gas tap after using.