4
2. To fill the kettle, remove it from the power base and open the lid by pressing the lid
release button, fill with the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout. The water level should not
exceed the MAX mark or sit below MIN level. Too little water will cause the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is firmly in place before plugging the power
outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the
On/Off switch
, the indicator will
light up. Then the kettle will start to boil the water, once the water has been boiled the
On/Off switch
will be off automatically. You can shut off the power by lifting the
On/Off switch
at any moment during boiling water. If you want to boil water again,
only press down the
On/Off switch
directly to restart the kettle.
NOTE: Ensure that the On/Off switch is free of obstructions and the lid is firmly
closed, the kettle will not turn off if the switch is constrained or if the lid is opening
.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water
may result in scald, don’t open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the
On/Off switch
is pressed down again. The kettle
may be stored on the power base when not in use.
NOTE: Always disconnect the power supply when not in use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the boil-dry protection will
automatically switch off the power. If this occurs, allow the kettle to cool before filling
with cold water to reboil.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it down completely
before cleaning.
