3
If the power cord is damaged, it must be replaced by an authorized service agent to avoid
any electrical hazard.
A short power supply cord is provided to reduce the hazards resulting from entanglement
or tripping over a longer cord.
Use of an extension cord is not recommended. If, however, it is necessary to use one,
always ensure that the marked electrical rating of the extension cord is equal to or greater
than the electrical rating of this appliance to reduce the risk of fire or cord burn-
out/overheating.
Ensure that the extension cord does not hang over edges or is placed where it can be
pulled on by small children or animals or inadvertently tripped over.
USING YOUR SNACK MAKER
Before using your snack maker for the first time, wipe the surfaces of the cooking plates
with a damp cloth and dry thoroughly with a soft dry cloth.
Smear the cooking plates with butter or margarine. For added non-stick – spray with a
non-stick cooking spray.
Insert the plug into the mains and switch on.
Keep the machine closed to allow the unit to preheat for approximately 5 minutes.
When the green “ready to use” light comes on, the appliance has reached its set
temperature.
Use this heating time to prepare your sandwich, waffle mixture or meat/vegetables etc.
Open the unit fully and place the food onto the bottom plate.
Carefully close the two halves of the unit, do not force it shut.
Steam will be ejected from between the two plates. Care must be taken to ensure that
your fingers do not come into contact with the hot surfaces or the steam.
Lock the two plates together while cooking/toasting is taking place by using the locking
clip –
except when using the waffle plates.
Note: During cooking/toasting, the pilot light will cycle on and off while the thermostat
maintains the correct temperature.
Food will be cooked in 2-8 minutes or longer depending on the type of food and
personal taste.
Open the unit and remove food from the non-stick plates with a wooden or plastic lifter.
Never use a metal knife or spatula as this may damage the non-stick coating.