HOW TO ASSEMBLE/DISASSEMBLE
The Salton Pro-Mixer can be used as a stand mixer (Ill. 1)
or hand mixer (Ill.2). Before assembling or disassembling
make sure the power cord is unplugged and the speed
control is at ‘0’ on the Mixer and Bowl Speed is on ‘Off’.
To connect the Hand Mixer to the Mixer Head
Press and hold the Tilt Button on the Mixer Head. Lift
the Head upward until it locks into the tilt position (Ill 3).
Position the rectangular holes in the back of the Hand Mixer
over the 2 retaining prongs in the Mixer Head.
Press down on the Hand Mixer until it clicks (locks) into
place (Ill. 4). The Mixer Head is still in the raised position.
To lower, press and hold the Tilt Button while gently
lowering the Hand Mixer down fully until it clicks into
position (Ill. 5).
To disconnect the Hand Mixer from
the Mixer Head
Raise the Mixer Head into the tilt position as described above.
Once the Mixer Head is in the tilt position you can remove the
Hand Mixer by pressing the Hand Mixer Release Button and
sliding the Hand Mixer up and away from the Mixer Head.
To install the Bowl
Place the bottom of the Bowl on the turntable in the Base. Turn the Bowl
clockwise until it locks into position with a click.
To remove the Bowl
Turn the Bowl counter-clockwise and lift away from the Base.
5
Ill.1
Ill.2
Ill.3
Ill.4
Ill.5
KM-25 Booklet v03 7/23/04 5:45 PM Page 18
