BEFORE FIRST USE
1. Remove all packaging and tape. Make sure that you have the Ice Basket
and Ice Scoop before discarding packaging.
2. Place the Ice Maker away from direct sunlight and other sources of heat,
such as a stove, furnace and or radiators.
3. Position the Ice Maker so that it is 12” (30 cm) away from the wall
on the left hand side.
4. After positioning the Ice Maker, wait 2 hours before starting.
5. Wash the interior, the Ice Basket and Ice Scoop. See the Care
and Cleaning section.
IMPORTANT NOTE:
In the event that the power to the Ice Maker is inadvertently disconnected
during the ice making cycle or there are warning lights blinking on the control
panel, press the Power Button once so that it is blinking, then unplug the unit.
Wait a few minutes until the Ice Maker warms up and the ice has fallen from
the Evaporator Fingers. Empty the Water Tray by following the directions in #2
of the Care and Cleaning section. Wait 3 minutes then plug the Ice Maker into
the wall outlet. Follow the directions in the How to Use section.
HOW TO USE
1. Ensure that the Drain Plug on the left side of the unit is closed.
2. Plug the Ice Maker into the wall outlet and the green power indicator
light will blink (approximately every 5 seconds).
3. Open the Cover and remove the Ice Basket.
4. Fill the Water Reservoir.
NOTE:
Do not fill above the water level
mark at the back of the Water Reservoir.
5. Replace the Ice Basket and close the Cover.
6. Press the Power Button. The Ice Maker automatically selects the medium
“M” ice size. To change to either the small or large ice size, press
the Select Button until the light is lit up beside the desired ice size.
4
SAL6-505 Booklet Salton Ice Maker IM-2010_EN_VF.qxd 27/09/06 15:37 Page 4
