Salsco 413H, Operator And Parts Manual

Page: 10 / 22

O:\Manuals\413..416.425MANUAL\413H_416B_425S_rev.10.30.17.doc
- 10 -
SERVICE SCHEDULE
1. Grease all main bearings once a day. DO NOT OVER GREASE. Wipe extra grease off
bearings.
2. Be sure to clean entire machine. Should it become necessary to remove the exhaust
chute, to clean out the machine, make sure the key has been removed from the engine.
3. Sharpen/change chipper blades: REMOVE KEY FROM ENGINE . Remove bolt
on impeller housing. Open impeller housing to expose impeller and chipper blades. Do
not reach in and hold impeller with your hand, instead use a piece of 2" x 4" wood to
push impeller housing. When you reassemble, be sure to use Locktite. We use Locktite,
Blue 242, removable at the factory. It is also advisable to discard bolts and replace them
with new bolts. Sharpen blades as you would sharpen a lawn mower blade, under angle
edge only. Sharpen blades as evenly as possible.
REMINDER! SALSCO, INC. has a
blade sharpening service. Call SALSCO, INC. for full details, 800-872-5726.
4. Recommended Bed knife adjustment
is 3/16” from chipper blades. When adjusting
bed knife, check the distance on all chipper blades. MAKE SURE all bolts are tightened
properly after adjusting bed knife.
HINT: It is strongly recommended to have a set of blades and screws on the shelf, to
prevent downtime while blades are being sharpened.
HINT: Blades need sharpening after approximately 8 - 15 hours of use.
SERVICE SCHEDULE AS
NEEDED
DAILY WEEKLY MONTHLY
CLEAN MACHINE
GREASE DISC SHAFT BEARING
SHARPEN CHIPPER BLADES
CHECK & ADJUST BED KNIFE
CHECK ALL NUTS & BOLTS
X
X
X OR
X OR
X
X
X
X
X
X
CHECK ENGINE MANUAL FOR ENGINE MAINTENANCE SCHEDULE
NEVER, UNDER ANY CIRCUMSTANCES START THE ENGINE WHEN UNIT IS
OPEN OR AT ANY TIME DURING SERVICE OR ROUTINE MAINTENANCE