Cautions
To Reduce the potential risk of fire, electrical shock or injury :
1.
All electrical wiring (both installation and repair) must be done by a licensed electrician and in accordance with local and
state ordinances.
2.
No modifications, addition or deletions should be made to the pump without MFG approval.
3.
Before starting motor, fill the tub with water to the level recommended by MFG. Never run dry.
4.
Motor have built in automatic reset overload protector that guards against damage from mechanical or electrical problems
such as low voltage, locked pump or similar abnormal conditions. Remember, if the timer device is still on, these motor will
restart automatically - as soon as they cool down.
5.
Do not relocate pump without prior approval from manufacturer.
Warning
●
To reduce the risk of injury, DO NOT permit children to use this product unless they are
closely supervised at all time.
●
To reduce the electric shock, replace damage cord immediately, and DO NOT use extension
cord to connect unit to electric supply.
SYMPTOMS
PROBABLE CAUSES
RECOMMENDED ACTION
Will not turn on
No power to motor
Check switch and circuit breaker / connection
Pump runs slow
Note wired required voltage
Correction voltage from power source
Pump humms
Particle stuck in the impeller
Clean out impeller / check terminal connection
Pump humms
Pump jammed
If unable to turn, please send for repair
but will not turn
Noisy pump
Particle in the pump
Remove debris in the volute
Pump leaks
Loose union
Tighten union
Worn seal
Replace shaft seal
Pump cavitation
Air from jets getting in suction
Direct directional flow fitting away from suction
Pump runs but
Air lock
Turn on and off the pump up to 10 times / take out air by opening
no jet action
the union and bleed out the air. Tighten union after air is out.
Union Nut
Union Male 1 ½ in.
O Ring
Front Volute
Front Discharge
Impeller
Seal
Volute O Ring
Back Volute
Power Cord
Airswitch
TROUBLE SHOOTING
