32
WARNING!
The motor noise increases when the tank is full or blocked. Immediately stop the
machine and empty the waste water tank.
1.
Make sure that the equipment is disconnected from the power supply.
2.
For wet vacuuming, the foam filter must be used. To use the foam filter, first remove
the paper bag, the fabric bag or the HEPA filter, if applicable. Make sure the foam filter
is clean and dry. Mount the foam filter on the filtration basket carefully.
3.
Re
-
install the upper part back to the tank and fasten it in place.
4.
Make sure that the cleaning detergent has been mixed with the recommended water
proportion, pour it into the detergent tank and close it tightly. Connect the suction hose
using the connector to the cap, push the connector down and turn it.
5.
Connect the connector at the end of the suction hose on the rear side of the vacuum
cleaner into the tank cap, push the connector down and turn it.
6.
Make sure that the transparent detergent inlet hose is correctly fitted around the
suction hose and fastened using supplied clips.
7.
Connect the vacuum hose to the suction inlet on the front of the tank.
8.
Insert the connector at the end of the detergent inlet hose into the detergent outlet
nozzle on the front side of the motor housing.
9a.
Insert the sprayer handle into the upper part of the suction hose.
9b.
Attach the large spraying nozzle to the metal tube and connect them with the sprayer
handle. Attach the hoses for detergent inlet. The hose is attached by pushing into the
connecting piece.
10. The spraying jet at the end of the inlet hose is slid into the fastening on the bottom side
of the spraying nozzle.
10b. In the jet, there is a groove that must fit into the pin in the hose attachment to ensure
the correct direction of the jet outlet.
11.
Turn the switch to Position II for simultaneous detergent application and dirty liquid
suction.
12. By pressing the spraying lever on the sprayer handle, apply the detergent to the area
being cleaned.
To clean fabrics and upholstery, attach the small sprayer head directly into the sprayer
handle, and connect the hoses for detergent inlet.
